Uline S-20992 Assemblage page 2

5. Attach milled-edge side to unmilled-edge side and
base. (See Figure 5)
Figure 5
6. Attach unmilled-edge side to both sides and base.
(See Figure 6)
Figure 6
7. Fit top between the two sides and slide into place.
(See Figure 7)
Figure 7
PAGE 2 OF 6
ASSEMBLY CONTINUED
8. Be sure top is fully seated, then attach with
remaining clips. (See Figure 8)
9. To remove, insert tool into raised pocket on long
leg of clip and rotate tool towards center of panel.
(See Figure 9)
1-800-295-5510
uline.com
Figure 8
NOTE: Always cover clip with hand when
removing.
Figure 9
0822 IS-20992