Genesis GBDS430 Manuel D'utilisation page 8

UNpACKING AND CONTENTS
IMpORTANT:
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. failure to do so could result
in serious personal injury.
A
CONTENTS IN PACKAGE
Item Description
A. Belt/Disc Sander
C. Work Support
e. Miter Gauge
G. Screws
WARNING:
the tool, plug in power cord or turn the switch on until the missing or damaged parts are
replaced.
ASSEMBLY
WARNING:
power source before adjusting, adding accessories, or checking a function on the tool.
INSTALLING OR REPLACING SANDING DISC (FIG 3)
One 6" sanding disc (3) and the disc guard (1) are pre-installed
at the factory.
To Replace the Sanding Disc
1. unplug the sander from the power source.
2. using a Phillips screwdriver, loosen and remove two screws (5a)
on the disc guard (5).
3. Remove the disc guard.
4. Peel off the old sanding disc (6).
5. Remove the backing from a new sanding disc. Align perimeter
of disc with sanding plate and firmly press the disc into position.
6. Reinstall the disc guard as shown on FIG 3. The disc guard can be adjusted up and down to cover sanding disc
for more protection.
INSTALLING OR REPLACING SANDING BELT (FIG 4)
A sanding belt is pre-installed and aligned at the factory.
To Replace the Sanding Belt
NOTE:
Use 4"x36" (100mm x 914mm) sanding belt. On the smooth side of the sanding belt,
there is a directional arrow. The sanding belt must run in the direction of the arrow.
Belt/Disc Sander
Operator's Manual
Due to modern mass production techniques, it is unlikely the tool is
fIG 2
QTY
1
1
1
2
If any parts are missing or damaged, do not attempt to assemble
Always be sure that the tool is switched off and unplugged from the
G D
f
C
Item Description
B. Work Table
D. Table Lock Knob
F. Allen Key
Operator's Manual (Not Shown)
fIG 3
GBDS430
B
E
QTY
1
1
1
6
5
5a