Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SpECIfIC SAfETY RULES fOR BELT/DISC SANDERS
WARNING:
fROM REpEATED USE) REpLACE STRICT ADHERENCE TO pRODUCT SAfETY RULES. If
you use this tool unsafely or incorrectly, you can suffer serious personal injury!
• Make sure the belt/disc sander is on a firm, level surface and properly secured to
avoid injury from unexpected movement.
• Unplug the tool before making adjustments, repairs, maintenance or storing.
• Always switch off the tool before unplugging it to avoid accidental starting when replugging
the tool into a power source.
• Wear eye protection and dust mask.
• Do not operate the sander until it is assembled and installed according to this manual's instructions.
• Do not use the tool if the switch does not turn it on and off. Defective switches should be immediately
replaced by an authorized service center and the machine not used under repairs are completed.
• Always support work piece with miter gauge, work support or table.
• Keep fingers away from pinch points between housing and sanding belt or disc.
• Maintain 1/16 in. (1-2mm) clearance between table and sanding belt or disc.
• Maintain proper adjustment of sanding belt tension and alignment.
• Never sand more than one piece at a time.
• Always feed the work piece from left to right against the direction the sanding belt is rotating.
• Use extra caution with large, very small or awkward work pieces. Never use this tool to
sand a piece too small to hold by hand.
• Avoid awkward operations and hand positions where an unexpected or sudden slip could
cause your hand or fingers to move into the sanding belt or disc.
• Never stand in line with the path of work piece.
• Do not operate in rain or in damp locations.
• Grounding required.
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMfORT OR fAMILIARITY WITH pRODUCT (GAINED
SAVE THESE INSTRUCTIONS
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
5
Publicité
Table des Matières
