Publicité
Les langues disponibles
Les langues disponibles
Advancing the Cord
Each time the Trimmer starts or comes to a complete stop, the Trimmer's Cutting Cord automatically
advances and cuts itself to 5-1/2"; resulting in an eleven (11) inch cutting swath.
You can also manually advance the Cord.
1. Release the orange Control Bar to stop the Trimmer motor and remove the Safety Key.
2. Push in the white Button on the side of the Spool Housing (Figure 43) and pull the Cord to
advance it. The Cord advances in small increments so you might have to push the Button a few
times.
NOTE: Try not to advance the Cutting Cord past the Trimmer Shield. If you do pull out too much Cord, the
Cutter on the Trimmer Shield automatically trims the length of the Cord (Figure 44).
BE CAREFUL, THE EXCESS CORD WILL FLY OFF WHEN YOU START THE TRIMMER AND COULD BE
DANGEROUS.
White Button
Figure 43
Safety Tips for using the Trimmer
Following these tips will provide safe operation and enhance the performance of your Trimmer:
•
Always stop the motor before toggling the Mower/Auxiliary Switch.
•
You can adjust the cutting height of the Trimmer by raising or lowering the Mower's cutting
height level. Make sure you first stop the motor and remove the Safety Key before changing the
height.
•
Stop the motor and remove the Safety Key before changing the position of the Trimmer Head or
Housing.
•
The Battery will drain more quickly in the Edger mode. You can realistically expect up to 45
minutes of use in the Edger mode, and approximately one (1) hour in Trim mode. This is when
having an extra charged Battery comes in handy. Be sure to remove the Safety Key when you
change the Battery.
•
Be sure to clean the Trimmer Head frequently keeping the cooling vents and air intake holes free
of debris.
48
All manuals and user guides at all-guides.com
Figure 44
Cord Cutter
Housing
1-866-NEUTON1 (638-8661) www.neutonowners.com
Publicité
