TFK Joggster III Notice D'utilisation page 12

OPERATING AND ASSEMBLY MANUAL
Please note:
If your buggy has swivel front wheels, turn them so they face forwards and fix
them in this position. This makes the buggy less likely to tip over when
carrycots or Group 0 seats are fitted. All adapter pairs are labelled with L for
left and R for right. This refers to the directions as seen from behind the
buggy, in the direction of travel.
Notes on the Joggster range:
After the basic adapters (supplied with the TFK buggy) are fitted on the
Joggster Twist, Joggster III or Joggster X, the adapters for the carrycots or
shells are fitted in exactly the same way.
Notes on the Buggster range:
Slide the adapters for the Buggster onto the folding joint, until they click into
place. Please always check that the parts are securely fastened before use.
The various adapters only differ in the way they connect to the carrycot or
shell.
Fig. I: Basic adapter, Joggster Twist / III
Fit the basic adapter (1) to the frame crossbar and slide it over the two rear
holes (direction of travel). Secure the basic adapters in place by tightening
the supplied screws (2).
Note: For the Joggster Twist and Joggster III models, adapters can be used
with or without a seat cover. The seat cover must be in the first horizontal
position and the basic adapter screwed on to the frame crossbar through
the two front holes (direction of travel). PLEASE NOTE: Buggies will be more
stable, if you remove the seat cover and use the rear holes!
Fig. II: Basic adapter, X3/X4
You can fit the two basic adapters (4) supplied with the Joggster X to the
holes provided on the folding joint of the Joggster X. Secure the basic
adapters in place with the two supplied screws (5). The long screw goes in
the front hole (direction of travel).
Fig. III: TFK Quick fix carrycot on Joggster Twist / III / X2
Attach the Quick fix adapters (7) supplied with the carrycot to the
appropriate basic adapters, until you hear them click and lock into place.
Push the carrycot into the two Quick fix adapters (7), until it clicks into place.
Fit the carrycot so that your baby is facing you. To remove the Quick fix
carrycot, press the two small levers (6) in the recessed grips on either side of
the carrycot and lift up.