Grundig SM 8680 Mode D'emploi page 19

INFORMATION­ ___________________________
Tips­for­blending
To add ice cubes to mixtures while the blender
█
is operating, add one cube at a time through
the cap . Wait a few seconds before adding
A
the next ice cube so that the blender can prop-
erly blend the ice.
To add food while the blender is operating,
█
remove the cap and drop the ingredients
A
through the opening. Be sure to cut the food
into about 2-5 cm pieces to fit through the
opening. Replace the cap
finished adding ingredients.
When blending solid food, such as raw veg-
█
etables, cooked or uncooked meat and fruits
always cut them into no larger than 2-5 cm
pieces before placing them into the glass jug.
Blend no more than 2 cups of these food at a
time. This will speed the blending process and
reduce wear on the blending blades.
Always place liquid ingredients in the glass jug
█
first, unless a recipe specifically states other-
wise.
To blend beverages, place all ingredients in
█
the glass jug at the same time.
Avoid overblending. Usually, you will need to
█
blend for a few seconds.
Overblending may cause food to become
█
mushy.
Cleaning­and­care­
Caution­
Never use petrol, solvents, abrasive cleaners,
█
or metal objects and hard brushes to clean the
appliance.
The blades of the cutter unit are very sharp!
█
Handle the blades with utmost care in order to
avoid injuries.
Never clean the blades with your bare hands.
█
Clean the jug blender after each use. Do not
█
let any food remnants harden on and inside
the jug blender. This will make it more difficult
to clean it later.
All manuals and user guides at all-guides.com
when you have
A
Do not use boiling water. The blade assembly
█
bearings have been designed with a lifetime
lubricant; exposure to boiling water may
damage these bearings and shorten the life of
the blender.
1­­
T urn the appliance off and disconnect it from
the wall socket.
2­­ A llow the appliance to cool down.
3­­ R emove the glass jug
ing G . Rinse it with water to remove any large
food particles that may have accumulated in
the glass jug.
4­­
R eplace the glass jug
G .
5­­ P lace 1 to 1 ½ cups warm water with some
drops of mild cleanser into the glass jug
switch to speed "4" for a few seconds. Dirts in-
side the container will be cleaned substantially
in that way.
6­­
R emove the glass jug from the motor housing
and rinse with water. Repeat as necessary.
7­­
I f there is still dirt left, separate the container
F
and blade set and clean each by following
the below steps.
8­­ T urn over the glass container
from the motor hous-
D
on the motor housing
D
and
D
D
D .
ENGLISH 19