Abus TVHD80100 Notice D'utilisation page 86

Configuration
TAB General
Parameter Setting
NIC Typ Set the transmission speed of the in-
stalled network card here.
Tip: 10M/100/1000M self adaptive
Enable DHCP Tick the box if the IP addresses are
assigned dynamically via DHCP in the
network.
DHCP activated: Subsequent entry
fields are inactive (parameters as-
signed via DHCP).
Note:
If the IP addresses are assigned man-
ually, ensure that DHCP is not active
(box not ticked).
IPv4 Adress Address of the network device in the
network (manual assignment)
IPv4 Usually 255.255.255.0
Subnet Mask
IPv4 Default Address of the gateway for Internet ac-
Gateway cess
IPv6 Adress 1 Currently no functioning
IPv6 Adress 2 Currently no functioning
IPv6 Standard Currently no functioning
Gateway
MAC Adress Hardware address of the installed net-
work card
MTU (Bytes) Describes the max. size of the largest
protocol data .
Preferred Address of the Domain Name Server
DNS Server (usually the IP address of the gateway)
Alternate DNS IP address of the alternative DNS
server
Report net- Box ticked:
work
Acoustic alarm in the event of a net-
interruption
work interruption
Note
In certain modes some of these settings cannot be
selected.
PPPOE
1. Tick the PPPOE box, enter the user name (Internet
access ID) and password, then confirm the pass-
word.
2. Confirm the settings by pressing Apply.
Warning
Use PPPOE only if there is no router available.
DDNS
1. To use the ABUS DDNS function, you must first set
up an account under www.abus-server.com. Please
note the FAQs on the website when doing this.
Tick the "Enable DDNS" box, enter 'ABUS DDNS' as
2.
the "DDNS Type", then enter www.abus-server.com
or "62.153.88.107" under "Server Address".
3. Confirm the settings by pressing Apply. The IP ad-
dress of your Internet connection is now updated on
the server every minute.
86