AEG DGB3523S Notice D'utilisation page 55

WARNING!
Risk of injury! Use protective gloves to
replace the lamp.
Risk of damage to the appliance! Do not
use sharp edged tools!
Replace the burnt light bulb in accordance
with the specifications:
Power (W)
Socket
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
The lamp does not operate.
The appliance does not absorb
enough vapours.
8. ENVIRONMENTAL CONCERNS
Recycle materials with the symbol
packaging in relevant containers to recycle it.
Help protect the environment and human
health by recycling waste of electrical and
electronic appliances. Do not dispose of
4
E14
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
The lamp is defective.
The motor speed is not adequate to
the appearing vapours.
. Put the
Voltage (V)
Dimensions (mm)
ILCOS D Code (accord‐
ing IEC 61231)
To replace the lamp:
1. The lamp cover has two slots on each
side (1). Use a flat non sharp plastic tool.
Gently remove the lamp cover from the
appliance (2).
2. Replace the lamp.
3. Mount the lamp cover.
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp. Refer to the
"Care and Cleaning" chapter.
Change the speed of the motor.
appliances marked with the symbol
the household waste. Return the product to
your local recycling facility or contact your
municipal office.
55
220 - 240
37 x 100 (diameter x
length)
DRBB/F-4-220-240-
E14-37/100
with