Nosiboo Pro Guide De Démarrage Rapide page 8

INSTRUCTIONS FOR USE & SETTINGS
1
Switch on the device by turning the
control button.
2
Select the correct suction power.
Setting recommendations:
min setting for newborns
*
middle setting for babies
*
max setting for small children and for
*
pre-schoolers
4
Gently insert the clean, dry nose tip into
the child's nostril.
Move the nose tip around gently to make
*
sure that you get all areas of the nostril.
CLEANING
Remove the connecting
*
tube and the nose tip,
then take apart the
Colibri head.
Wash the parts
*
with liquid soap and
lukewarm water.
The effective and strong (max) suction power has been
proven safe for nasal aspiration by ENT doctors.
If the mucus is thin, you can use the device at a lower
setting. If it is thick, you can use the device at a higher
setting than normal.
3
Hold your child in a stable position.
Aspirate the nose of infants after laying them
*
into a stable position and hold their head
during the process.
You may also sit them in an infant bouncer or
*
infant seat.
If the child is already able to sit, sit them in your
*
lap. In this case, do not lay the child on their
back during the aspiration.
Use the brush for
*
cleaning the nose tip.
Switch off the device after
5
use with the control button
(OFF setting). The device
should be connected to or
disconnected from the power
network only if the control
button is in OFF position (the
device is switched off).
If you do not use the device
for a longer period of time,
disconnect it from the power
network.
Do not disconnect the device
from the power network
during operation!
You can soak the
*
parts in a disinfection
liquid just make sure
the liquid is safe to
use for baby
equipment.