Mounting The Front And Surround Speakers - Yamaha NS-P270 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Mounting the front and surround
speakers
You can place the front and surround speakers (and
surround back speaker in an NS-P276 system) on a
shelf or rack, set them on the floor, or mount them
on a wall or speaker stand.
To mount the speakers on a wall:
1.
Affix screws to a firm wall or wall support as
shown below. (Use tapping screws 3.5 to 4mm
in diameter.)
Wall/ wall
support
70 mm
Holes
10 mm
Minimum
20 mm
2.
Suspend the speaker by mounting the holes in
the speaker's rear panels on the protruding
screws.
70 mm
Note: Make sure that the
screws are securely affixed in
the narrow part of the holes.
Cautions
:
• Each front or surround speaker weighs 0.8 kg
(1.8 lbs.). Do not mount the speakers on thin plywood
or on a wall made of soft surface material. Otherwise,
the screws may pull out of the surface and the
speakers may fall, possibly damaging the speakers or
causing personal injury.
• Do not affix the speakers to a wall using nails,
adhesives, or unstable hardware. Long term use and
vibration may cause the speakers to fall.
• To avoid accidents resulting from tripping over loose
speaker cables, affix the cables to the wall.
• Mount the speakers in a wall location that will be
unlikely to result in injury to an individual's head.
Rear view
Installing the speakers on commercially
available speaker stands:
You can mount the front, surround, and surround
back speakers on a speaker stand. When you
installing the speaker on commercially available
speaker stand, you need to attach a bracket to the
bottom of the speaker using a screw.
60 mm (2-3/8")
Bracket (AAX34790)
(option)
M4 screw
(AAX12390)
(option)
Insert only M4
screws through the
outside holes.
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ns-p276Nx-e270Nx-c270Sw-p270

Table des Matières