Installing And Charging The Battery; English - THOMSON TH101 Guide D'utilisation

1. Inserting a SIM card
• Switch off the phone and remove the rear cover.
• Insert the SIM card correctly into the relevant card slot
( see figure below ).
• Then replace the battery and cover.
CAUTION: The 4G functions can only be used on one SIM card.
2. Inserting a MicroSD
• Switch off the phone and remove the rear cover.
• Insert the memory card into the relevant slot.
• Then attach the rear cover.
CAUTION: Inserting or removing a SIM card or a MicroSD
card requires the smartphone to be completely switched off.

3. Installing and charging the battery

Charging the battery:
• To charge the battery, connect the USB cable (supplied) to the USB port of your
smartphone and the other end to the mains adaptor (supplied). Then connect the mains
adaptor to a power outlet.
• The battery charge icon illuminates during charging and indicates the charge status.
• When the battery is fully charged, you can disconnect the USB cable from the device
then from the power outlet.
IMPORTANT:
• The smartphone is only recharged via its USB port.
• Ensure your smartphone is fully discharged before charging it for the first time.
• The battery must be charged for at least 5 to 8 hours when first charged.
Note: You can use the device when it is being charged. In this case, the battery may take
longer to charge fully.
4. Switching the smartphone on and off
To switch the smartphone on, press the On/Off button located on the side of the

English

smartphone for 3 seconds.
If the smartphone is switched on, press for less than a second on
the button to put the device into standby mode. Press it again
to leave standby mode.
To switch off the smartphone, press the On/Off button for 3 seconds
until a menu appears, then touch the Off button and confirm.
- 12 -