Publicité
Les langues disponibles
Les langues disponibles
EN
8.5
INSTALL THE BATTERY PACK
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
•
Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.6
REMOVE THE BATTERY PACK
1. Push and hold the battery release button (15).
2. Remove the battery pack from the machine.
9
OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1
START THE MACHINE
1. Push the lock-out button (2) and pull the trigger (1).
WARNING
IMPORTANT
WARNING
English
9.2
STOP THE MACHINE
1. Release the trigger to stop the machine.
9.3
ADJUST THE LENGTH OF THE
CUTTING LINE
The machine has an auto-feed head. It will damage the
machine if you hit the head to try to advance the line.
15
If the cutting line does not automatically advance, it can be
tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
3. Resume trimming.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
9.4
ADJUST THE LENGTH OF THE
SHAFT
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Push the lock button (12) and move the lower shaft (7) to
the desired position.
3. Release the lock button.
8
2
1
NOTE
NOTE
NOTE
NOTE
Publicité
