Cembre B35-TC025 Notice D'utilisation page 5

The tool can be held in one hand while positioning the conductor with the other.
Residual battery capacity level is automatically displayed after every cycle.
The part references "B35-TC025 ; B35-TC025A" include the following:
– Basic tool complete with battery.
– Spare battery.
– Battery charger complete with CBA96-144 adapter.
– Plastic carrying case VAL P22.
2. INSTRUCTIONS FOR USE
2.1) Setting
With the tool in the rest position, proceed as follows:
Insert the conductor between the blades at the desired cutting point.
For a running conductor, release the latch (66) and open the tool head.
O
PENING THE UPPER BLADE MUST BE DONE ONLY WHEN THE TOOL IS IN REST
POSITION
With the conductor on the lower blade (26), close the tool head and fully secure the latch
(16).
Before commencing the cutting operation ensure that the latch (16) is fully secured:
partial closure may damage the tool head.
2.2) Blade advancement
Grip the tool fi rmly and comfortably and press the operating button (3) to activate the
motor-pump group for the advancement of the lower blade (26). To halt the advancement,
release the operating button (3) and the motor will cut out.
2.3) Cutting
By keeping operating button (3) pressed, the motor continues to operate: the ram will
gradually move the lower blade to cut through the conductor.
The motor will continue to operate after the maximum pressure relief valve has activated.
No further cutting force is applied, the oil is bypassed and returned to the reservoir.
2.4) Blade retraction
Press the pressure release button (8), the ram will retract and open the blades.
2.5) Head rotation
For ease of operation the tool head can rotate through 180°, allowing the operator to work
in the most comfortable position.
Warning: do not attempt to rotate the head when the hydraulic circuit is pressurised.
31 4
(Ref. to Fig. 1 page 2)
( (26)
LOWER BLADE COMPLETELY RETRACTED
ENGLISH
).