Description (Fig. 1); Items Supplied; Proper Use; Safety Regulations - KING CRAFT KCT 205 H Mode D'emploi

1. Description (Fig. 1)

1 Saw table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Parallel stop
8 Motor
9 Power cable
10 Stand
11 On/Off switch
12 Star grip handle for parallel stop
13 Table strut
14 Angle stop
15 Star grip handle for height adjustment
16 Star grip handle for stop rail
17 Star grip handle for table strut
18 Star grip handle for saw blade guard

2. Items supplied

Carbide-tipped saw blade
Parallel stop
Angle stop
Push stick
Bench-type circular saw

3. Proper use

The KCT 205 H bench-type circular saw is designed
for the slitting and cross-cutting (only with the angle
stop) of all types of timber, commensurate with the
machine's size.
The machine is not to be used for cutting any type of
roundwood.
The machine is to be used only for its prescribed
purpose.
Any use other than that mentioned is considered to
be a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting such cases of misuse. The machine is to be
operated only with suitable saw blades that
correspond with the machine specifications
contained in these operating instructions. It is
prohibited to use any type of
cutting-off wheel. To use the machine properly you
must also observe the safety regulations, the
assembly instructions and the operating instructions
cited in this manual. All persons who use and service
the machine have to be acquainted with this manual
and must be informed about its potential hazards. It
is also imperative to observe the accident prevention
regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
Contact with the saw blade in the uncovered
saw zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if essential ear-muffs are not
worn.
Harmful emissions of wood dust when the
machine is used in closed rooms.
4. Important notes
Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.

Safety regulations

Caution: Whenever you use electric tools, be
sure to take basic safety precautions in order to
rule out any risk of fire, electric shock and injury
to persons. For example:
Keep these safety instructions in a safe place.
Observe all these instructions before and while
you work with the saw.
Guard against electric shock!
Avoid body contact with earthed parts.
When equipment is not being used it should be
kept in a dry, closed place out of children's
reach.
You will work better and more safely if you keep
your tools sharp and clean.
Check the power cable regularly and have it
replaced by an authorized specialist at the first
sign of any damage.
Check your extension cables regularly and
replace them if damaged.
When working outdoors, use only extension
cables that are approved for outdoor use and
which are marked accordingly.
GB
13