Danby Silhouette DFF9102BLP Manuel D'utilisation page 4

Safety Instructions
ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the
electrical current. This appliance is equipped with a
cord having a grounding wire with a grounding plug.
The plug must be plugged into an outlet that is
properly installed
and grounded.
WARNING - Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as
to whether the appliance is properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your
refrigerator to extension cords or together with any
other appliance in the same wall outlet. Do not splice
the cord.
IMPORTANT WARNING
An empty refrigerator is a very dangerous attraction
to children. Remove either the gasket, latches, lids
or doors from unused appliances, or take some other
action that will guarantee it harmless.
DON'T WAIT! DO IT NOW!
Installation
Remove exterior and interior packings, wipe the outside
thoroughly with a soft dry cloth and the inside with a wet,
lukewarm cloth. Avoid placing the cabinet in a narrow
recess or near any heat source, direct sunlight, or
moisture. Let air circulate freely around the cabinet. Keep
the rear of the refrigerator 5 inches away from the wall.
Location
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of the
refrigerator and any adjacent wall.
3. Avoid direct sunlight and heat. Direct sunlight may
affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
The refrigerating system in this refrigerator is a "Frost
Free" system. This type of system requires no user
intervention (i.e. defrosting) other than selecting required
cooling temperatures and the usual care and
maintenance.
To avoid vibration, the cabinet must be set level. This is
accomplished by adjusting the (2) front leveling legs
located under the refrigerator cabinet. To start the
refrigerator, turn the temperature control (1-MAX) to the
position corresponding to the desired cooling.
The refrigerator temperature will vary depending on the
quantity of the food stored and on the frequency with
which the door is opened.
1. THERMOSTAT DIAL: For controlling the temperature
inside the refrigerator/freezer. Turns the motor on as
soon as the temperature rises above the desired
level.
2. SEPARATE FREEZER SECTION: holds ice cube
tray and storage for frozen food.
3. ICE CUBE TRAY: Ice cubes are easily removed from
the tray. (Not shown)
4. TEMPERED GLASS SHELVES: Odor resistant,
rustproof, and removable for easy cleaning.
5. MAGNETIC GASKET: Tight fitting door seal keeps
all the cooling power locked inside. No hooks or
latches.
6. CRISPER WITH TEMPERED-GLASS SHELF:
Easy interior viewing.
7. CANSTOR TM DOOR LINER: Holds 355 mL cans of
pop, juice, or beer.
8. GALLON DOOR STORAGE: can be adjusted to hold
smaller items with slide in rail.
9. 2 LITER TALL BOTTLE STORAGE:
holds 2 liter bottles.
1
4
2
2
5
7
9
8
6