Ega Master 51648 Instructions De Montage page 24

Fitting an interface on a frame
This method applies only when one unit is used.
The interface on the frame must be arranged so that the drive wheel (1) of the unit is aligned
parallel to the existing steering castors (2). The following points must be observed when arran-
ging the drive wheel:
If it is arranged off-centre and the weight is distributed unevenly on the frame, the frame
can be raised on one side when the drive wheel is extended. Consult your sales partner in this
situation.
The further the drive wheel is installed on the outside of the frame, the greater the risk of
crushing when the drive wheel is raised or lowered.
Nº. Description
1 Drive wheels
2 Fixed castors
Fasten the interface to the desired position.
Fitting interfaces on a frame
This method applies only when two units are used.
The interfaces on the frame must be arranged so that the drive wheels (1) of the units are
aligned parallel to the existing fixed castors (2) of the frame.
24