Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Creating the prerequisites for installation
Ensure that the carriage onto which the device should be installed fulfils the following prere-
quisites:
You must have adjusted the frame rollers' tread and rolling resistance to the mass to be mo-
ved.
If you have any questions, please contact your sales partner.
An interface with corresponding threaded holes or through holes must be provided on the
frame.
The interface must be designed in such a way that the drive-related forces to be expected
during operation can be safely transmitted. The design must also take
the unit's lifting force into account. Your sales partner will support you with the design.
The distance between the floor and the interface must be 170 mm.
The interface must be installed so that the unit's main direction of travel is the same as the
driven frame's main direction of travel.
When used as a drive for hospital beds and medical equipment, the following requirements
must also be met:
The requirements set down in IEC 60601-52 are met
At least four hospital bed rollers with the 'full lock' function are available
The roller system has a central locking system.
All applicable laws, standards and guidelines are observed and followed.
The control unit, which is not included in the scope of delivery, has to be approved for use by
the manufacturer.
Please contact the manufacturer if you wish to use a control unit that is not supplied or ap-
proved by the manufacturer.
The position of the interface differs depending on the intended purpose. It can be mounted
both centrally between the frame castors and off-centre. However, central positioning is the best
in all cases.
Contact your sales partner if you have any questions about the interface position.
Ensure that the following preparations have been taken at the interface:
The interface must fulfil the prerequisites mentioned in the previous section.
The interface must have three holes of 9 mm diameter or three M8 threaded holes in order
to fasten the device. The screw-in depth must be at least 10 mm. The arrangement of the faste-
ning holes depends on the main direction of travel (see arrow).
PREPARING INSTALLATION
MOUNTING THE INTERFACE
23
Publicité
Table des Matières
