Publicité
English
2. Insert the roll paper and pull out a small amount of paper, aligning
the paper with the guide, as shown below.
3. Close the roll paper cover; then
tear off the roll paper.
Note:
Be sure to close the cover completely by
pushing down on the middle of the
cover.
Troubleshooting
ERROR LED on or flashing
❏ Check to see that the roll paper cover is closed and check the
PAPER OUT LED. Close the cover or replace the paper if necessary.
❏ If the printer has been printing a lot, the head may be hot. Wait for
the head to cool. Printing will resume automatically.
❏ If the autocutter is jammed, turn the printer off and then back on.
❏ If the roll paper cover will not open, see the section below.
❏ Turn off the printer and then turn it back on. If the LED is still
flashing, call your supervisor or a service person.
Paper jam
Turn off the power and open the roll paper cover and check for a paper
jam. If there is a paper jam, remove the jammed paper and follow the
instructions in the "Installing the Roll Paper" section to prepare the
printer for printing.
6 TM-L90 User's Manual
All manuals and user guides at all-guides.com
Publicité
