Husqvarna 322C Manuel D'utilisation page 32

Assembling the loop handlebar
(322C)
• Position the handle on
the shaft. Note that the
handle must be mounted
below the arrow on the
shaft.
• Fit the bolt, securing plate
and wing nut as shown in
the diagram.
• Tighten the wing nut.
Assembling the loop handlebar
(322L)
• Clip the loop handle onto
the shaft. Note that the
loop handle must be
fitted between the arrows
on the shaft.
• Slide the spacer into the
slot in the loop handle.
• 322L: Fit the nut, washer
and bolt.
325L-X/L-XT: Fit the
nut, knob and bolt. Do
not overtighten.
• Now adjust the trimmer
to give a comfortable
working position. Tighten
the bolt/knob.
32
– English
ASSEMBLY
Assembly of the trimmer head
It is extremely important
that the disc drive's/support
flange's guide engages
correctly in the cutting
equipment's centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
!
WARNING!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter "Technical
data" . If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.