Publicité
Les langues disponibles
Les langues disponibles
9 Basic settings
You can configure the appliance to meet your needs.
9.1 Changing basic settings
Requirement: The appliance is switched off.
Press and hold
and
1.
a The display shows the first basic setting.
Press .
2.
a The current value flashes on the display.
Use the settings area to set the required value.
3.
Press .
4.
a The appliance implements the setting.
Press
.
5.
Tip: The setting can be changed at any time.
9.2 Changing the signal duration
When your appliance is switched off, you hear an aud-
ible signal. You can change the duration of the signal.
Press and hold
for approx. six seconds.
▶
a The signal duration switches between short and
long.
a The appliance applies the signal duration and dis-
plays the time.
10 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
10.1 Cleaning products
Only use suitable cleaning products.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive detergents.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
Wash sponge cloths thoroughly before use.
▶
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
for a few seconds.
9.3 Setting the time
Note: After connecting the appliance to the power or
following a power cut, a signal sounds and several
zeros are shown on the display. It may take a few
seconds until a signal sounds and you can set the
time.
Requirements
¡ An audible signal sounds.
¡ 12:00 is shown on the display.
¡ The indicator light lights up via
Set the time via the settings area.
1.
Press
.
2.
9.4 Hiding the clock
To reduce the standby consumption of your appliance,
you can hide the clock.
Press
.
1.
Press
.
2.
To view the clock, press
10.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use any harsh or abrasive cleaners or sharp
▶
metal scrapers to clean the glass on the appliance
door, as they may scratch the surface.
Read the information on cleaning products.
1.
→ Page 31
Observe the information on cleaning the appliance
2.
components or surfaces.
Unless otherwise specified:
3.
Clean the components of the appliance with hot
‒
soapy water and a dish cloth.
Dry with a soft cloth.
‒
10.3 Cleaning the cooking compartment
ATTENTION!
Incorrect cleaning may damage the cooking compart-
ment.
Do not use oven spray, abrasive materials or other
▶
aggressive oven cleaners.
Read the information on cleaning products.
1.
→ Page 31
Clean with hot soapy water or a vinegar solution.
2.
Use oven cleaner to remove very heavy soiling.
3.
Basic settings en
.
again.
31
Publicité
