Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Step 4.
Find the stud where you will be attaching the left side of the changing station
to the wall. Measure up from the fl oor 44" (1118 mm), at the center of the stud
and mark the wall. Mark holes using a level and measuring tape to make sure
holes are precisely positioned. Hold
unit in place to check. Use a 1/8"
drill bit to make pilot holes and
the four ¼" x 3" panhead screws
with washers (supplied) to attach
the unit to the wall studs. This will
place the bottom of the station
26½" (673 mm) from the fl oor and
the top of the bed at 33" (838 mm)
from the fl oor.
If the wall surface is masonry or
tile over wood studs, use a 7/32"
masonry drill bit for the pilot hole
until you hit the stud. Change bit to
1/8" regular drill bit. Use the four
¼" x 3" panhead wood screws with
washers (supplied).
If the wall has wood studs that
are not on 32" (813mm) centers,
has metal studs or an underlying
surface of concrete block, drill with a ½" (12 mm) masonry bit. (You may have
to purchase toggles before installing.) You must allow a minimum of inside wall
space for toggles to turn depending on toggles used. Insert and tighten toggles.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in
dispenser with sanitary bed liners. Replacement parts and additional liners can
be purchased from your local distributor or by calling toll free 888.733.3456 or
303.539.8300 in the U.S.
3
Publicité
