Switch Off; Filling With Oil - Zipper Maschinen ZI-ABH1500D Manuel D'utilisation

12.2.3 Switch off

Take the pressure off switch push button to stop the stroke.
•
For continuous operation, press and release the push button switch to release the fixation.
•

12.2.4 Filling with oil

The gear motor is supplied without oil!
•
Fill gearbox-lubricating oil before starting the E-motor!
•
Before adding gearbox lubrication oil, disconnect the demolition hammer from the mains.
As an oil tank is installed, the demolition hammer can be used about 20 days to refill without oil. The
daily use is about 3 - 4 hours.
Recommended gear oil: 15W40
Add oil, if in this position (or upright) in the oil level is less than 3mm, or no oil is visible.
•
Remove the oil level using the supplied Allen wrench. Make sure that the rubber seal on the
•
thread fits well and is not damaged when screwing
To check, insert the oil level indicator and pull easily fixed.
•
Oil level should be around 3 mm from the lower edge
•
After filling of oil drag the oil level again firmly
•
ZIPPER MASCHINEN GmbH
ZI-ABH1500D / ZI-ABH1700D
www.Zipper-Maschinen.at
W A R N I N G
29