Safety Recommendations - SKF TIH 100m Mode D'emploi

Because the TIH 100m generates a magnetic ield, people wearing
•
a pacemaker must not be within 5 m (16 ft) of the TIH 100m during
operation. Electronic equipment, such as wristwatches, may also be affected.
• During the heating process observe a safety distance of 50 cm (1.6 ft)
with the workpiece, the heater coil or the core.
• Follow the operating instructions at all times.
• Be certain that the voltage supply is correct.
• Electrical arcing may occur when a potential difference exists between the
TIH 100m and the workpiece. This is not dangerous to human beings and
will not cause damage to the TIH 100m or the workpiece. However, the
TIH 100m must never be used in areas where there is a risk of explosion.
• Do not expose the TIH 100m to high humidity.
• Never operate the TIH 100m without a yoke in position.
• Never operate the TIH 100m with the cable of the remote control between
the vertical supports of the yoke.
• Do not modify the TIH 100m.
• Use proper handling equipment when lifting heavy workpieces.
• Avoid contact with hot workpieces. Wear the supplied heat resistant gloves
to handle hot workpieces.
4

Safety recommendations

SKF TIH 100m