i.t.works 2040 Manuel D'instructions page 43

2040 Manual-E/F/(515542-00)
TV MODE
CHANGING TV MODE SETTING
CHANGING TV MODE SETTING
The camera allows you to view individual files and record clips on the television. To begin,
check your television documentation to determine what video standard you should set your
camera to either NTSC or PAL.
MAIN MENU
EV
+
–
WB
WB
Brightness
Setup
How to change the TV Mode setting:
1. Slide the Mode Switch to (
2. Press the MENU button to view the (
3. Press until Setup is highlighted.
4. Press to enter the Setup menu.
5. In the Setup menu press
6. Press to change the setting to NTSC or PAL.
7. Press the MENU button to exit.
CONNECTING THE CAMERA TO THE TV
Connections
1. Connect the TV-Out cable into the jack marked VIDEO or VIDEO
IN on your television.
2. Turn on your television.
3. Set the television to video mode according to the instructions in
the owner's manual. (This is usually channel 3, 4 or AV).
4. Turn the camera on by pressing the (
5. Connect the other end of the cable into the VIDEO port located in
the cable connection panel. (fig.1.1)
Using the TV as a Live Viewfinder:
1. Connect the camera to the TV.
2. Turn the camera on.
3. Slide the Mode Switch to (
4. The TV will become a live viewfinder.
Note: You may record your TV Mode session by using your VCR. Please refer to your
VCR documentation to learn more about recording.
2004:04:30 5:54 PM
SETUP
Time-out 60S
TV NTSC
PlayLogo O f f
Language
).
) Main Menu.
until TV is highlighted
) Power button.
) Review mode.
41
Page 41
SETUP
Time-out 60S
TV PAL
PlayLogo O f f
Language
fig.1.1