Dell XC6320 Mise En Route page 4

All manuals and user guides at all-guides.com
1 Push the latch release buttons on the midpoints of the end piece to open the
rail latches (see Figure 1).
2 Align the end pieces of the rails on the vertical rack flanges to seat the pegs
in the bottom hole of the first U and the top hole of the second U.
NOTE: The rails can be used in both square-hole and round-hole
racks (see Figure 1).
Figure 1. Pushing the Latch Release Buttons
NOTE: To remove the rails, push the latch release button on the
midpoints of the end piece and unseat each rail.
3 Engage the end of the rails and release the latch release button to have the
latches locked in place.
4 On each vertical rack flange on the back, put two screw bases into the two
square holes right above the rail (see Figure 2).
5 Install the chassis stabilizer shipping brackets (optional) on the back
rack flanges.
6 Install and tighten the screws.
NOTE: To transport systems already installed in the rack, ensure
that the two chassis stabilizer shipping brackets (optional) are
in place.
4
| Getting Started With Your System