Publicité
Les langues disponibles
Les langues disponibles
The electronic control consists of a thermostat that allows you to choose the temperature of the internal liquid from 30°C to 70°C.
1- ON/Stand-by
button
By simply pressing the
ON/Stand-by
When the device goes into "Stand-by" mode, the buzzer sounds twice for 0.5 seconds, and when the device goes into "Comfort" mode, the buzzer
sounds once for 1 second
LED off
"Stand-by"
Red LED lit
"Comfort": heating element on
Blue LED lit
"Comfort": heating element off
Red/blue
Error message, the heating element is deactivated, contact the
LED blinking
service centre
2-
Knob
(3)
Rotation: used to set the desired liquid temperature.
• Clockwise rotation = increases the temperature up to 70°C;
• Counter-clockwise rotation = decreases the temperature down to 30°C.
Button: pressing the knob activates the "Boost" function. (The heating element is activated at maximum power for 2h)
"Boost" mode activated
When the 2 hours are up, the regulator returns to the previous mode.
24-hour timer:
to activate this function, it is necessary to press the knob for 3
(the maximum temperature than can be reached is 70°C). When the time is up, it returns to "Comfort" mode for 22 hours, then returns to "Boost" mode
for another 2 hours, and continues indefinitely. During the first cycle, "Comfort" mode lasts 21 hours.
"Boost"
mode for 2 hours (green LED blinking) (2)
"Comfort"
mode for 22 hours (green LED) (2)
12-hour timer:
to activate this function, it is necessary to press the knob for 5
(the maximum temperature than can be reached is 70°C). When the time is up, it returns to "Comfort" mode for 10 hours, then returns to "Boost" mode
for another 2 hours, and continues indefinitely. During the first cycle, "Comfort" mode lasts 11 hours.
"Boost"
mode for 2 hours (yellow LED blinking) (2)
"Comfort"
mode for 12 hours (yellow LED) (2)
in accordance with article 14 of the Directive 2012/19/EU of 07/07/2012 on waste electrical and electronic equipment.
• The symbol shown above, present also on the equipment, indicates that it has been placed on the market and that, when the user decides to get
rid of it, it must be disposed of in separate waste collection (including all the components, sub-assemblies and consumer materials which are an
integral part of the product).
• For information on the systems for collecting these appliances, please contact the company or another subject enrolled in the various National
Registers for other countries in the European Union. Waste produced in the home (or of similar origin) may be consigned to systems for the separate
collection of urban waste.
• When buying a new appliance of an equivalent type, it is possible to hand over the old equipment to the seller. The seller will then contact the
subject in charge of the collection of the equipment.
• The appropriate separate collection of the scrapped equipment and the subsequent operations of processing, recovery and environment-
compatible disposal, allows the avoidance of potential negative effects on the environment and on human health, while favouring the recycling and
recovery of the component materials.
The unauthorised disposal of the product by the user entails the application of the sanctions contemplated under the national approval of Directives
2011/65/EU, 2008/98/EC and 2015/1127/EU.
INSTRUCTIONS FOR USE OF THE ELECTRONIC THERMOSTAT (fig. A)
INSTRUCTIONS FOR USE AND OPERATION
(1)
button it is possible to change from "Stand-by" to "Comfort" mode and vice versa.
(red LED
blinking) (2)
To interrupt the
"Boost"
seconds. Heating starts for 2 hours, irrespective of the set temperature
seconds. Heating starts for 2 hours, irrespective of the set temperature
INFORMATION FOR USERS
function, just press the knob
again.
Publicité
