Operating Procedures - Haussmann PNT240-PN Manuel De L'utilisateur

OPERATING PROCEDURES

SETUP
AIR SOURCE
The HAUSSMANN nailer is designed to operate on clean, dry, compressed air,

regulated at 70-110 PSI. The preferred system would include a filter, a pressure
regulator, and an automatic oiler located as close to the tool as possible. Within 15
feet (5 m) is ideal. Do not use bottled air or gases. Please see below:
Nailer
All compressed air contains moisture and other contaminants that can harm

the internal components of the tool. An air line filter will remove most of these
and significantly extend the life of the tool. Ensure the in-line oiler has sufficient
oil. If an in-line oiler is not available, place 2 drops of oil into the tool's air inlet
at the beginning of each workday. More than this will be expelled from the
tool's exhaust during firing.
Air fitting: The nailer should be equipped with a 1/4" NPT male quick

connector. To prevent accidental cycling even though disconnected, the tool
must always be connected to the air supply in such a way that all air pressure
in it is released when the coupling is disconnected.
CAUTION:
All air line components (including hoses, pipe, connectors, filters, & regulators,

etc.) must be rated for a minimum working pressure of 150 PSI or 150% of the
maximum system pressure, whichever is greater.
Disconnect the tool from the air supply before performing maintenance, clearing a

jammed fastener, leaving the work area, moving the tool to another location, or
handing it to another person.
CONNECTING THE TOOL
Turn the compressor on and set the regulator to proper pressure for the size and type
of fasteners being used.
After reading and understanding this entire manual, connect tool to air supply.
20
PNT240-PN
Air hose
Quick coupling
Regulator
Oiler Filter
Air connector
Fig.2
Fig.3
!