Tefcold BC85 Manuel D'utilisation page 6

IMPORTANT SAFETY PRECAUTIONS
Before you use your cooler please read this instruction manual carefully.
Use this appliance only for its intended purpose as described in this owner's manual.
This cooler must be properly installed in accordance with the installation instructions before it is used.
Never unplug you cooler by pulling on the power cord. Always grasp the plug firmly and pull straight out
from the wall outlet.
1) Repair or replace immediately, all electric service cords that have become frayed or otherwise damaged.
Do not use a cord that shows cracks or abrasion damage along its length, the plug or the connector end.
2) Unplug your cooler before cleaning or before making any repairs.
NOTE: If for any reason this product requires service, we strongly recommend that a certified technician
perform the service.
3) Do not operate your cooler in the presence of explosive fumes.
4) The power supply must be properly grounded.
5) Do not use an adapter plug or extension cord.
6) Do not use the unit in the immediate surroundings of a bath, shower or swimming pool.
7) Before discarding or storing, we recommend that you remove the door and leave the shelves in place. This
will reduce the possibility of danger to children.
8) Do not store food in cooler as the interior temperature may not be cool enough to prevent spoilage.
INSTALLATION
It is advisable to clean the inside of the cooler with lukewarm water using a mild detergent, and then
to dry it thoroughly prior to use.
The temperature in the appliance will depend on:
The temperature in the room
The frequency and duration of periods when the door is open
How many items there are in the cooler.
It may therefore be necessary to adjust the thermostat from time to time.
The refrigeration system of the cabinet is designed to operate with the cabinet located on a flat surface.
Avoid tilting the cabinet side.
If the cabinet must be tilted on an angle for handling or moving purposes, allow it to sit in an upright position
20 to 30 minutes prior to plugging it in and starting the cooling of the storage compartment.
Grounding plug and socket should be provided in accordance with local regulations. The cable-size should
meet the cooler's requirements. The unit must be connected to proper electrical network, which is shown on
the nameplate, through an omnipolar circuit-breaker. To assure the proper function of the cooler, please
observe the following recommended.
1) To ensure the circulation, the unit should be kept at 2 cm, away from the wall.
2) Locate the unit away from direct sunlight. This will enable you to obtain the best performance and save
energy.
3) Under no circumstances should the top grid be covered by any object. It will preclude the warm air from
circulating.
5