Publicité
Les langues disponibles
Les langues disponibles
18
IMPORTANT: Plug the device into power mains only AFTER the device has been completely
and correctly assembled.
1. Place the motor unit onto a level, dry, smooth, waterproof worktop.
2. Install the jar on the motor unit so that the arrow on the bottom part of the handle
points open padlock icon on the side of the motor unit.
3. Turn the jar clockwise until it locks in place and the arrow points closed padlock.
4. Place the lid on the jar and turn it clockwise until it locks in place. Place the measuring
cup on the lid.
Speed adjustments:
• Pulse: Rotate and keep the knob to "P" (function is active as long as you keep the knob in
that position). Release the knob to turn off the function. Suggested for ingredients that
require short time processing (e.g. nuts).
• 1
mode: Low speed for delicate foods processing with a folding motion. Suggested for
st
combining wet and dry ingredients as well as chopping.
• 2
mode: High speed for breaking down ingredients. Suggested for liquefying.
nd
EN
Preparing ingredients
The ingredients to be processed need to be precut, peeled and pitted if necessary. Please
note, very hard skin and pits can damage the blades of the device. When the ingredients are
too big, the device may jam. Prepare the ingredients accordingly.
Usually, a certain amount of drinking water or other liquids has to be added to facilitate the
smooth running of the appliance. The proportion of the food and water is 2:3. The amount of
mixture should not exceed the max level as indicated on the jar.
Using blender
1. Make sure the device is properly assembled. Connect the device to power supply mains
socket.
2. Insert ingredients into the jar (either through the opening in the lid or detach the lid).
3. Use the knob to set desired speed.
4. When processing is completed, turn it off and disconnect from power mains. Rotate the
jar anticlockwise and remove it from the motor unit.
ASSEMBLY
OPERATION
Owner's manual
Publicité
