Hansgrohe PuraVida 15473 1 Serie Instructions D'installation page 4

10452181
1.
4
Installation
Cut the plaster shield so that it extends ⅜" above the
surface of the finished floor.
Remove the flush housing screws using an 8 mm Allen
wrench (not included).
Remove the flush housing.
Position the tub filler on the rough (1).
2.
Pivot the tub filler so that it faces the correct direction
().
Make sure that the tub filler is level.
English
Turn the water off at the main
before beginning!
Do not discard the screws!