Axis Communications P33-VE Serie Guide D'installation page 24

AXIS P33–VE Network Camera Series
Complete the Installation
1. Rotate the black shield inside the dome cover so it does not cover the lens.
1
Black shield
2. If required, attach the weather shield to the camera before you attach the dome cover:
- Remove the two screws in the dome cover.
- Transfer the washers from the screws to the screws used on the weather
shield, and attach the weather shield.
3. Make sure the rubber gasket sits securely on the dome cover.
4. Clean the dome with a dry soft cloth to remove dust and finger prints and use a blower
to remove dust from the lens.
5. Attach the dome cover to the unit casing by tightening the four screws.
6. When the dome cover is in place, make sure that the camera is properly focused.
24