BETEX iDuctor Manuel D'utilisation page 8

A coil or flexible coil must be connected to the unit. This connection is extremely robust
thanks to the patented clamping mechanism. Coils and flexible coils are connected or
removed by simultaneously depressing both buttons on the side of the unit. It is also
possible to lie the unit down flat so that both buttons can be depressed with a single
motion. An alternative method is to place the unit between the legs and depress the
buttons with the knees, keeping both hands free.
The coil's contact points are then fully inserted in the holes at the front of the iDuctor 1.
The buttons should then be released. The patented clamping mechanism will ensure that
the spiral is held very firmly in place. Before using the unit check that the contacts have
been fully inserted and that the connection is tight.
C A U T I O N
!
Select a coil which will fit closely around the object to be heated without touching it.
This allows the optimal transfer of magnetic energy so that the object heats up as fast
as possible, as well as preventing the coil's protective sleeve from being damaged by
contact or wearing faster due to overheating.
6