Items Supplied - BETEX iDuctor Manuel D'utilisation

Introduction
The iDuctor uses the phenomenon of induction to heat magnetisable metal components
such as nuts. Whether a particular material can be heated can be determined by
experimentation. A set of eight different induction spirals and a flexible induction coil
are available to allow heating of a wide range of components: small drive components,
bearings, rings, housings, pipes, nuts, bolts, small surfaces.
Read this user manual rst before you use the iDuctor!

Items supplied

The iDuctor is supplied as a complete set in
a robust box with the following contents:
∎ iDuctor 1
∎ 1 flexible inductor, 2 mtr
∎ heat resistant gloves (150°C)
∎ a mains cable with IEC Lock
∎ user manual
∎ safety data sheet
3