Publicité
Les langues disponibles
Les langues disponibles
Screen
To change the Activation Settings:
• Tap the buttons to toggle
between the different Activation
settings:
Pick up sensor: the Control Panel
switches on when it is tilted.
Firm keys: the Control Panel
switches on and/or sends out IR
when a firm key is pressed
Cursor keys: the Control Panel
switches on and/or sends out IR
when one of the cursor keys is
pressed.
To calibrate the touch screen:
1 Tap the Calibrate button.
2 Follow the on screen instructions
to tap the 4 corners of the
screen.
The touch screen is calibrated.
Note
The screen is calibrated in the factory. Do not use this function unless you experience problems
with the touch screen.
Support
Maintaining the Control Panel
Take care not to damage the touch screen
• Do not drop the Control Panel or subject it to any strong impact.
• Use the stylus enclosed or your finger to tap the touch screen.
Attention Never use an actual pen, pencil or other sharp object on the touch screen to avoid scratching
the touch screen.
Protect the Control Panel from temperature extremes
Keep the Control Panel away from heaters and other heat sources.
The Control Panel is not waterproof
The Control Panel should not be exposed to rain or moisture.
Do not store or use the Control Panel in any location that is extremely damp or wet.
When you have spilled water on the Control Panel, you have to turn it off by switching the Power
switch to 0.
Place the Control Panel in a clean environment to dry.
To change the Time out and
the Brightness settings:
• Tap the '-' and '+' buttons
to adjust the settings.
TSU9600 Starter's Guide
To exit the
Settings pages:
• Press the right
firm key labeled
Exit.
6
Publicité
