Publicité
Les langues disponibles
Les langues disponibles
Charging the battery (fig. D)
• Make sure that the appliance is switched
off. The battery will not be charged with the
on/off switch (4) in the on position.
• Place the appliance on the charging base
(7) as shown. The charging indicator will
be lit.
• Plug in charger and leave the appliance
on charge for at least 9 hours. While
charging, the charger may become warm.
This is normal and does not indicate a
problem. It is safe to leave the appliance
connected to the charger indefinitely. The
charger automatically reduces power
consumption when charging is complete.
• When charging is complete, the LED will
turn off.
WARNING:
below 39°F (4°C) or above 104°F (40°C).
Switching on and off (fig. E)
• To switch the appliance on, slide the on/
off switch (4) forward to position I.
• To switch the appliance off, slide the on/
off switch (4) back to position 0.
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter
to remove dirt; however, in order to keep the
suction force optimized, the dust container
and filters must be cleaned regularly.
Cleaning the dust container and
filters (fig. F - J)
There are two methods of cleaning
the bowl, a quick empty method and a
thorough clean method.
For the quick empty method use the
following instructions.
• Press the release latch (6) and open the
container door (5) (fig. F).
• Empty the dust container (11).
• Close the dust container door (5). Make sure
that the release latch (6) clicks into place.
For the thorough clean method use the
following instructions.
• The dust container (11) is attached to
the body of the appliance. To remove the
dust container, press the dust container
release button (2) and rotate the dust
container (11) counterclockwise and
carefully slide the dust container clear of
the appliance.
D
Do not charge the battery at ambient temperatures
E
F
5
n
Publicité
