AudioSonic HF-1256ITR Mode D'emploi page 6

BATTERY INSTALLATION
Insert a "Cell" size batteries into the battery compartment. Be sure that the batteries
are inserted correctly to avoid damage to the remote control. Always remove the
batteries when the remote control will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your set.
Slide out cover and install single " Cell" battery with polarities as shown
Notes:
• If the distance required between the remote control and the appliance decreases,
the batteries are exhausted. In this case replace the batteries with new one.
• Power button on main unit must be 'On' in order for Remote Control to operate.
SENSOR WINDOW OF THE RECEIVER
• Even if the remote control is operated within the effective range, its operation may be
impossible if there are any obstacies between the appliance and the remote control.
• If the remote control is operated near other appliances which generate infrared
rays, or if other remote control devices using infrared rays are used near the
appliance, it may operate incorrectly.
RADIO OPERATION
General operation
• S et the "FUNCTION" selector to "RADIO" mode.
• S elect desired band by using the "BAND" selector.
• A djust radio frequency to your desired station by using the "TUNING" control.
• A djust the "VOLUME" control to the desired level.
FM / FM-stereo reception
• S et the "BAND" selector to FM mode for MONO reception.
• S et the "BAND" selector to FM ST. mode for FM STEREO reception.
The Stereo indicator light up to show FM ST. mode.
6
Instruction Manual
For better reception
• F M - This appliance has a FM antenna located at the rear cabinet.
This wire is completely unraveled and extended for better reception.
• A M - This appliance is equipped with a built - in directional ferrite AM antenna.
Rotate the appliance to get better reception.
CD OPERATION
General operation
PLAY / PAUSE ( ) Press to start playing CD disc.
Press again to stop playing CD operation temporarily.
Press again to resume playback.
SKIP + & ( ) Press to go to the next track or back to the previous track.
S KIP - ( ) P ress and hold while playing until you find the point of
the sound.
S TOP ( ) Press to stop all CD operation.
Playback
• S et the "FUNCTION" selector to "CD" mode.
• O pen the CD door and place a CD disc with the label up in the CD compartment.
• C lose the CD door.
• F ocus search is performed if disc is inside. Total number of tracks is read and
appears on the display.
• Press the "PLAY / PAUSE" button to start playing CD disc.
• A djust the "VOLUME" control to the desired level.
• P ress the "PLAY / PAUSE" button again when you want to stop playback
temporarily.
• P ress the "STOP" button when finished.