Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed:
⁹⁄₁₆" Socket wrench
⁷⁄₁₆" Wrench
Parts Supplied:
6 ft. (182.88 cm) Workbench
Workbench
Workbench legs
(2 welded sets)
Leveling legs (4)
¹⁄₄" – 20 x ³⁄₄" Back panel
bolts (4)
³⁄₈" x 1¹⁄₂" Lag
screws (11)
¹⁄₄" Back panel washers (4)
Back panel
¹⁄₄
³⁄₄
" – 20 x
" Back Panel Bolts
Workbench Use Requirements
Intended for use in a garage.
Maximum weight limit is 1,000 lbs (453.5 kg) for the workbench.
Unpack the Workbench
1. Unpack the legs and hardware from the box. Verify contents. See
"Parts Supplied."
2. Remove the back panel and set it aside.
NOTE: Leave the workbench top on the cardboard during
assembly.
3. Remove the protective corners from the workbench top. The bolt
holes should be visible.
4. Dispose of/recycle all packaging materials.
Install Legs and Back Panel
1. Place each set of legs on the workbench underside and match
the bolt holes.
2
ASSEMBLY INSTRUCTIONS
Adjustable wrench
8 ft. (243.88 cm) Workbench
Workbench
Workbench legs
(2 welded sets)
Leveling legs (4)
¹⁄₄" – 20 x ³⁄₄" Back panel
bolts (4)
³⁄₈" x 1¹⁄₂" Lag screws (12)
¹⁄₄" Back panel washers (4)
Back panel
³⁄₈
1¹⁄₂
" x
" Lag Screws
2. Attach the back panel first using the four back panel bolts and
washers provided. Do not tighten the bolts completely at this
time.
3. Attach the legs to the workbench top using the eight lag screws.
The bolt holes in the legs are oval to allow space for minor
adjustments as you work. Tighten the lag screws using a ⁹⁄₁₆"
socket wrench.
4. Use the remaining lag screws to attach the back panel to the
workbench top.
5. Using a ⁷⁄₁₆" wrench, completely tighten the bolts attaching the
legs to the back panel.
6. Screw in the leveling legs. The leveling legs have a flat side
designed for use with an adjustable wrench if needed. The legs
should be at least ¹⁄₄" (0.635 cm) engaged in the workbench leg.
IMPORTANT: Screw the leveling legs in at least ¹⁄₄" (0.635 cm) or
a minimum of five full turns.
Complete the Assembly
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.
1. Using two or more people, stand the workbench upright and
place it in its final location.
Publicité
Table des Matières
