Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed:
¹⁄₂" Wrench (GearWall
®
panel
or GearTrack™ channel mount)
Phillips screwdriver
Parts Needed for Standard Mount:
¹⁄₄" – 20 x 1¹⁄₂" Lag screws (4)
Parts Supplied for 24" (60.96 cm) Cabinet:
Full-width shelf (1)
Mounting bracket (1)
¹⁄₄" x ¹⁄₂" Carriage bolts (2)
Parts Supplied for 30" (76 cm) Cabinet:
Full-width shelves (2)
Mounting brackets (2)
¹⁄₄" x ¹⁄₂" Carriage bolts (4)
Cabinet Use Requirements
Intended for use in a garage.
Maximum weight limit is 50 lbs (22 kg) for each shelf.
Maximum weight limit is 150 lbs (68 kg) for the 24" (60.96 cm)
cabinet.
Maximum weight limit is 200 lbs (91 kg) for the 30" (76 cm)
cabinet.
Unpack the Cabinet
1. Open the cabinet door.
NOTE: On the 30" (76 cm) cabinet you must first remove the key,
located in the handle, and unlock the door.
2. Remove and verify the contents. See "Parts Supplied" in "Tools
and Parts."
3. Dispose of/recycle all packaging materials.
2
CABINET/LOCKER SAFETY
Your safety and the safety of others are very important.
INSTALLATION INSTRUCTIONS
⁷⁄₁₆" Wrench (Standard
mount)
¹⁄₄" Flat washers (4)
Hex nuts (2)
Washers (2)
Hex nuts (4)
Washers (4)
Key (1)
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Install the Cabinet to the Wall
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
IMPORTANT: Decide if you are going to mount the cabinet on
Gladiator
®
GearWall
®
panels or GearTrack™ channels, or on a
standard wall. Follow the instructions that apply to your installation.
Install Cabinet to GearWall
GearTrack™ Channels
IMPORTANT:
®
Be sure the Gladiator
are installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
®
If Gladiator
GearTrack™ channels will be used to mount the
Welded-Steel Wall GearBox cabinet, they must be installed 18"
(45.72 cm) apart.
18" (46 cm)
®
Panels or
®
GearWall
panels or GearTrack™ channels
Publicité
Table des Matières
