GreenWorks G40LM35 Manuel D'opérateur page 7

6 TROUBLESHOOTING
Problem Possible cause
The handle is not The bolts are not
in position. engaged correctly.
The machine does The battery ca-
not start. pacity is low.
The bail switch is
defective.
The battery key is
not put in.
The machine cuts The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does Wet grass clip-
not mulch correct- pings attach to the
ly. deck.
The mulch plug is
missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
There is a high vi- The blade is un-
bration in the ma- balanced and
chine. worn.
The motor shaft is
bent.
English
Problem
The machine stops
Solution
during mowing.
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
pack.
Replace the bail
switch.
* If you cannot find the solution to these problems, go to the
Put in the battery
service center.
key.
7
ing area.
Voltage
Move the wheels
to a higher posi-
No load speed
tion.
Cut width
Wait until the
Cut height
grass dries before
mowing.
Grass catcher ca-
pacity
Install the mulch
plug.
Weight (without
battery pack)
Increase the blade
height.
Measured sound
pressure level
Empty the grass
Guaranteed sound
clippings from the
power level
grass catcher.
Battery model
Charger model
Replace the blade.
Vibration
IPX
1. Stop the mo-
tor.
8
2. Remove the
safety key and
(The full warranty terms and conditions can be found on
battery pack.
Greenworks webpage)
3. Disconnect the
The Greenworks warranty is 3 years on the product, and 2
power source.
years on batteries (consumer/private usage) from the date of
4. Inspect for
purchase. This warranty covers manufacturing faults. A faulty
damage.
product under warranty might be either repaired or replaced.
5. Repair the ma-
A unit that has been misused or used in other ways then
chine before
described in the owner's manual might be rejected for
you start it
warranty. Normal wear, and wear parts are not considered as
again.
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
7
Possible cause
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
TECHNICAL DATA
40 V
3500 / min
350 mm
20 - 70 mm
40 L
15 kg
L = 66,8 dB(A), K= 3 dB(A)
PA
L = 89 dB(A)
WA.d
G40B4/G40B2 and other BAF series
G40C and other CAF series
≤2,5 m/s², K=1,5 m/s²
IPX1
WARRANTY
EN
Solution
Increase the blade
height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.