Publicité
Les langues disponibles
Les langues disponibles
us_main.book.book Page 14 Tuesday, March 30, 2021 1:55 PM
14 INSTALLATION
3
When the appliance is completely stable and
all leveling feet are resting solidly on the floor,
tighten the locking nuts
Installing on Carpeting
Follow these instructions when installing the
appliance on carpeting.
WARNING
• The appliance is heavy. Two or more people are
necessary to install the rear leveling feet and
carpet spikes. Failure to do so can result in back
injury or other injury.
• Keep the appliance upright when moving and
installing it. If you lay the appliance on its side,
refrigerant may leak and cause the appliance to
malfunction.
1
Move the appliance into its final location
using the wheels at the bottom of the
appliance.
2
Install the two rear leveling feet at the rear
bottom of the appliance.
• Tip the appliance, do not lay it down, to
install the leveling feet.
3
Level the unit following the instructions in
Leveling the Appliance.
4
Install the four carpet spikes on the ends of
the leveling feet, with the shorter, octagonal
faces toward the front.
.
a
• Take care when handling the carpet spikes. They
• Keep fingers and hands out from under the
5
Reversing the Door
It is possible to reverse the direction of the door
swing. This should be done by the installer at the
time of installation, if desired.
NOTE
• If the direction of the door swing needs to be
WARNING
are designed to pierce through the carpet
backing and pad and are very sharp.
spikes when setting the unit in place to avoid
personal injury or product damage.
Level the appliance once more after installing
the spikes.
• If the carpet has very deep pile or padding,
the front feet may need to be extended
slightly to install the drip tray.
If installing the appliance on carpeting:
• Be sure to check and empty the drip tray
often.
• Do not open the unit during operation to
avoid condensation forming on carpet
surface, which may result in surface mold or
mildew.
• Keep the bottom of the cabinet dry when
filling or emptying water tanks. Keep the
outside of the water tanks clean and dry to
discourage growth of mold or mildew.
changed after installation, contact the LG
Customer Information Center.
Publicité
