Richell 94928 Manuel D'instruction page 4

Warnings!
●The width of the Adjuster Bolts on each side must be set equally to
avoid unexpected accidents and/or product damage as shown in
Figure 4.
●Tighten the Adjuster Knobs until clearance between the gate Door
and Main Frame is set to 0.8". This allows the tension-spring effect
to work properly to avoid unexpected accidents and/or product damage.
Figure 5
Side of the Main Frame
should be parallel to the wall.
8. Installation Check/How to Open and Close the Door
1. When correctly installed, the gate should not feel loose or wobbly
when tugged.
2. After assembly, open/close the Door several times to make sure
the Door works properly (please see Figure 6).
3. For the Door to lock properly, the Door Handle must snap into
the Upper Door Stopper when lifted and released. Make sure
the Door locks properly.
4. Make sure that Lower Door Stopper is centered over Bottom bar,
and locks in place securely.
9. How to Disassemble
Cautions!
●Be careful not to drop the product during disassembly.
●Make sure the Door is locked during disassembly.
10. How to Clean
●Wipe off this product with washing cloth after squeezed firmly using a mild detergent and water. Do not use a scrub brush
and/or a polishing powder as these may cause scratched, rust and discolor to the product.
●When using creosol or other disinfectants, make sure to dilute them, otherwise damage to the wooden finish or discoloration
may occur.
●Do not use harsh chemicals such as thinner, benzene or alcohol as these may cause damage/discoloration to the finish.
●After cleaning, wipe dry with soft cloth or place in a shaded area to air dry; do not place product in direct sunlight.
11. Specifications
UPC/JAN
803840 / 4973655
94928-3 50531-1
94929-0 50533-5
94930-6 50551-9
94931-3
50553-3
94932-0 50541-0
94933-7 50543-4
94934-4
50561-8
94935-1
50563-2
●Please note that product specifications and design may change without
prior notice for the purpose of quality improvement.
●There may be coating cracks at some joints and each product may
experience different coloration of the wood grain as frames are made of
natural wood.
●If you find something wrong with this product, please let us know. Thank you!
One side of Adjuster Knob
is longer than other side.
Rotate Adjuster Knobs counterclockwise to loosen and remove.
Dimensions
Width x Depth x Height (inches)
32.1- 36.4 x 2 x 30.5"
32.1- 36.4 x 2 x 38.4"
32.1- 62.8 x 2 x 30.5"
32.1- 62.8 x 2 x 38.4"
Figure 4
About 0.8"
One side of Adjuster Knob
is shorter than other side.
Figure 6
Bottom bar
Natural Wood, Plywood and Steel
4
Adjuster Bolts on
each side must be
set equally
Side of the Main Frame should
be parallel to the wall surface.
① How to open the door
①
While pushing Lock Button
②
forward with thumb.
②
Lift Door Handle.
Upper Door Stopper
Lower Door Stopper
Lower Door Stopper
Bottom bar
Materials
Designed by:
Richell Corporation, Japan
Distributed by:
Richell USA, Inc.
Grand Prairie, Texas 75050
Phone (972) 641-9795 Fax (972) 641-8495
www.richellusa.com
Visit us at
MADE IN VIETNAM