Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
m. Do not run the power tool while carry-
ing it at your side. Accidental contact
with the spinning accessory could snag
your clothing, pulling the accessory into
your body.
n. Regularly clean the power tool's air
vents. The motor's fan will draw the
dust inside the housing and excessive
accumulation of powdered metal may
cause electrical hazards.
o. Do not operate the power tool near
flammable materials. Sparks could
ignite these materials.
p. Do not use accessories that require
liquid coolants. Using water or other
liquid coolants may result in electrocu-
tion or shock.
4. Further safety instructions for
all operations
Kickback and Related Warnings
Kickback is a sudden reaction to a pinched
or snagged rotating wheel, backing pad,
brush or any other accessory. Pinching or
snagging causes rapid stalling of the rotat-
ing accessory which in turn causes the
uncontrolled power tool to be forced in the
direction opposite of the accessory's rota-
tion at the point of the binding.
For example, if an abrasive wheel is
snagged or pinched by the workpiece, the
edge of the wheel that is entering into the
pinch point can dig into the surface of the
material causing the wheel to climb out or
kick out. The wheel may either jump toward
or away from the operator, depending on
direction of the wheel's movement at the
point of pinching. Abrasive wheels may also
break under these conditions.
Kickback is the result of power tool misuse
and/or incorrect operating procedures or
conditions and can be avoided by taking
proper precautions as given below.
a. Maintain a firm grip on the power tool
and position your body and arm to
allow you to resist kickback forces.
Always use auxiliary handle, if pro-
vided, for maximum control over kick-
back or torque reaction during
start-up. The operator can control
torque reactions or kickback forces, if
proper precautions are taken.
b. Never place your hand near the rotat-
ing accessory. Accessory may kick-
back over your hand.
c. Do not position your body in the area
where power tool will move if kickback
occurs. Kickback will propel the tool in
direction opposite to the wheel's move-
ment at the point of snagging.
d. Use special care when working cor-
ners, sharp edges etc. Avoid bouncing
and snagging the accessory. Corners,
sharp edges or bouncing have a ten-
dency to snag the rotating accessory
and cause loss of control or kickback.
e. Do not attach a saw chain woodcarv-
ing blade or toothed saw blade. Such
blades create frequent kickback and
loss of control.
5. Additional safety instructions
for sanding operations
Safety Warnings Specific for Sanding
Operations:
a. Do not use excessively oversized
sanding disc paper. Follow manufac-
turers recommendations, when select-
ing sanding paper. Larger sanding
paper extending beyond the sanding
pad presents a laceration hazard and
may cause snagging, tearing of the disc
or kickback.
6. Additional safety instructions
for polishing operations
Safety Warnings Specific for Polishing
Operations:
a. Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or
trim any loose attachment strings.
Loose and spinning attachment strings
can entangle your fingers or snag on
the workpiece.
English
7
Publicité
Table des Matières
