Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Setting the temperature
1
Put the iron on its heel.
2
Set the required ironing temperature by turning the temperature dial
to the appropriate position (fig. 3).
Check the laundry care label for the required ironing temperature:
1 Synthetic fabrics (e.g. acrylic, nylon, polyamide, polyester)
-
1 Silk
-
-
2 Wool
3 Cotton, linen
-
If you do not know what kind(s) of fabric(s) an article is made of, determine
the right ironing temperature by ironing a part that will not be visible when
you wear or use the article.
Silk, woollen and synthetic materials: iron the reverse side of the fabric to
prevent shiny patches. Avoid using the spray function to prevent stains.
Start ironing the articles that require the lowest ironing temperature, such
as those made of synthetic fibres.
3
Put the plug in an earthed wall socket.
4
When the temperature light has gone out, wait a while before you
start ironing (fig. 4).
The temperature light will go on from time to time during ironing.
Using the appliance
.
Steam ironing
1
Make sure that there is enough water in the water tank.
2
Select the recommended ironing temperature (see chapter 'Preparing
for use', section 'Setting the temperature').
3
After the temperature light has gone out, set the steam control to
the appropriate steam position. Make sure that the steam setting you
select is suitable for the ironing temperature selected: (fig. 5).
q for moderate steam (temperature settings 2 to MAX)
-
-
w for maximum steam (temperature settings 3 to MAX)
The iron will start steaming as soon as the set temperature has been
B
reached.
Ironing without steam
1
Set the steam control to position O (= no steam).
2
Select the recommended ironing temperature (see chapter 'Preparing
for use', section 'Setting the temperature').
Features
.
Spray function
You can use the spray function to remove stubborn creases at any
temperature.
1
Make sure that there is enough water in the water tank.
2
Press the spray button several times to moisten the article to be
ironed (fig. 6).
Extra steam (GC1630/GC1620)
This function provides extra steam to remove very stubborn creases.
◗
The extra-steam function only works at temperature settings
between 3 and MAX.
1
Set the steam control to position w (= maximum steam) (fig. 7).
2
Press and hold the steam control for a maximum of 5 seconds (fig. 8).
3
Release the steam control and wait at least 1 minute before using this
function again to prevent water from dripping out of the soleplate.
All manuals and user guides at all-guides.com
3/9
Publicité
