KitchenAid 5KSMICM Manuel D'utilisation page 5

PRODUCT ASSEMBLY (CONTINUED)
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
6.
Plug the Stand Mixer into an earthed outlet.
ATTACHING THE ICE CREAM MAKER FOR BOWL-LIFT STAND
MIXERS
Before first use
Before using your attachment, remove the "Do not immerse in water" label. The Freeze Bowl,
Dasher, and Drive Assembly must be washed by hand.
1. Turn Stand Mixer off (0) and unplug.
2.
Place bowl-lift handle in down position and remove mixing Bowl.
IMPORTANT: Do not pour ice cream batter into the Freeze Bowl until all parts are
assembled and the Stand Mixer is running.
NOTE: Use the Freeze Bowl immediately upon removal from freezer, as it begins to thaw
once removed.
3.
Fit the Freeze Bowl in place over the locating pins. Press down on the back of the Freeze
Bowl until the bowl pin snaps into the spring latch.
NOTE: The Freeze Bowl is designed to fit most bowl-lift Stand Mixers. If the bowl pin at the
back of the Bowl is too long to snap into the spring latch, remove and rotate the Bowl so the
blank side faces the spring latch. Repeat step 3.
4.
Place the Dasher inside the Freeze Bowl.
ATTACHING THE DRIVE ASSEMBLY FOR BOWL-LIFT STAND
MIXERS
1.
Be sure the Stand Mixer is off (0) and unplugged.
2.
Make sure the bowl-lift handle is still in the down position and the Freeze Bowl and Dasher
are in place.
3.
Place Drive Assembly onto the Dasher, aligning the cutout with the Stand Mixer shaft.
4.
Raise the Bowl to connect the Drive Assembly to the Stand Mixer.
WARNING
Electrical Shock Hazard
5