Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Inspect the unit for cleanliness before use. Clean as necessary: See
Cleaning Instructions, page 10.
Be sure the pilot light is lit before operation. See Lighting the Pilot
Light, page 8.
The burner control knobs must be turned by hand only. Never use
tools to turn the control knob.
The control used in this gas griddle provides a continuous range of
settings from OFF to ON.
Light the burner by turning the control knob to the ON position until fire
forms completely in all sections of the burner. Set the control knob to
the desired position. The setting can be readjusted at any time.
OFF POSITION
Fig. 4 Burner Control
Cooking Recommendations:
Save energy by turning the temperature control knob OFF any time the
griddle is not in use. Gas burners provide full heat instantly, making it
unnecessary to leave the unit on during intermittent use.
To decrease the amount of grease contacting the deflectors, the grate
may be raised. Invert the grate so that the rear grate hooks are at the
bottom and the grate sits at a slight angle.
STANDARD POSITION
FRONT RAIL
RAISED POSITION
Fig. 5 Grate Positions
All manuals and user guides at all-guides.com
TO ON
TO OFF
ON POSITION
GRATE
INVERTED
OPERATION (continued)
NEVER attempt to force
or repair a stuck control
valve.
Contact your Authorized
Wells Service Agency for
repairs.
Forced or improperly
repaired valves pose the
risk of fire and/or
explosion.
If the pilot light should be
extinguished, turn off the
gas shut-off valve.
Allow the appliance to
vent for five minutes
before attempting to
re-light.
Exposed surfaces can be hot
to the touch and may cause
burns.
SUGGESTION:
For the most even heat
distribution, spread the
REAR RAIL
Char-Rock stones uniformly
over the support grid.
9
WARNING:
FIRE HAZARD
WARNING:
FIRE AND
EXPLOSION
HAZARD
CAUTION:
HOT SURFACE
Publicité
