Operating Elements - Medion AKOYA E53002 Mode D'emploi

Operating elements

Ref. Button
1
2
3
4
5
6 Operational display
1 2 3 4
(Ill.: Front operating elements)
Description
You will start the OSD (On Screen Display) with this button. Press this button
again if you wish to leave the OSD.
+ Power block, when the OSD is not activated
+ OSD block, when the OSD is not activated
Hold the key combination until the bar displayed has moved from left to
right completely, to activate/de-activate the block. A corresponding message
will appear on the screen.
Select a parameter and reduce its value with this button, when the OSD is
switched on.
If you are not in the OSD: Direct call-up of the Contrast/Brightness menu.
Select a parameter and increase its value with this button, when the OSD is
switched on.
If you are not in the OSD: change picture format.
Confirm the selection of the parameter to be changed with this button.
If you are not in the OSD: Direct call-up of the Automatic adjustment
menu.
You can switch the TFT monitor on or to the Standby mode with this button.
Shows the operational state. Please also refer to page 14.
Operating elements
5 6
11