Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ERROR TYPE
SR – Set value
Blink on cooler
set value screen
SR – Set value
blink on freezer
and cooler set
value screen
SR – Set value
blink on cooler
set value screen
"--"
What to do if your refrigerator does not operate:
Check that:
• Your fridge is plugged in and switched on,
• The fuse is not blown and there is not a power cut,
• Is the temperature adjustment right?
• The socket is no longer functioning. To check this, plug in an appliance that you know
is working into the same socket.
What to do if your refrigerator performs poorly:
Check that:
• You have not overloaded the appliance,
• The doors are fully closed ,
• There is no dust on the condenser,
• There is enough space for air circulation at the rear and side of the appliance.
If your fridge is operating too loudly:
Normal Noises
Cracking (Ice cracking) noise:
• During automatic defrosting.
• When the appliance is cooled or warmed (due to expansion of appliance material).
Click noise: Heard when the thermostat switches the compressor on/off.
MEANING
"Refrigerator
comp.
Not Cold enough"
"not cold enough
Warning"
Refrigerator comp.
too Cold
"Low voltage
Warning"
WHY
Ideal temperature for
Ref. Compartment is
+4
C. If you see this
o
warning your foods
have risk of spoiling.
It is combination of
"not cool enough"
error for both of the
compartments.
The foods starts to
freeze because of
the too much cold
temperature
When the power supply
gets lower than 170 V
the appliance gets to
steady position.
EN -24-
WHAT TO DO
1. Set the refrigerator
temperature to colder values
or set the super cooling mode
until the compartment gets to
normal temperature.
2. Do not open the door
much until this failure is off.
You will see this failure when
first starting the appliance.
It will be off after the
compartments gets normal
temperature
1. Check if the "Super cooling
mode" is on
2. Decrease the refrigerator
temperature values
This is not a failure. This
prevents any damages on
the compressor. This warning
will off after the voltage gets
required level
Publicité
Chapitres
Table des Matières
