Publicité
Les langues disponibles
Les langues disponibles
XP AZ 1018/17
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the warranty.
Problem
No sound
No power
Display does not function
properly/ No reaction to
operation of any of the
controls
no d1SC, Cd Err or
nF d1SC indication
Laser lens steamed up
CD playback does not work
The CD skips tracks
Poor cassette sound quality
Recording does not work
16
Great user manuals database on
14-11-2000 19:17
Pagina 16
Solution
– Adjust the VOLUME
– Power cord not securely connected. Connect AC
power cord properly
– Batteries dead /incorrectly inserted. Insert (fresh)
batteries correctly
– Electrostatic discharge
Switch off and unplug the set. Reconnect after a few
seconds.
– No CD inserted, insert a CD
– CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
– CD-(R) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up.Wait until lens has acclimatized
– Wait until lens has cleared
– Wait until lens has acclimatized
– CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
– CD damaged or dirty. Replace or clean CD.
– Program is active. Quit program mode
– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
– Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.
UserManuals.info
Publicité
