Philips AZ1018 Mode D'emploi page 13

XP AZ 1018/17
CD-Player
Programming track numbers
You may store up to 20 tracks in the
desired sequence. If you like, store any track
more than once.
1 In the STOP mode, press SEARCH ∞ or
§ for your desired track.
2 When your chosen track number appears,
press CD MODE/ PROGRAM once to
store the track.
The display shows
'P ro g' briefly followed by your selected
track number.
If you attempt to program without first
selecting a track number, no SEL is
shown.
3 Repeat steps 1 to 2 to select and store all
desired tracks in this way.
FULL is displayed if you attempt to
program more than 20 tracks.
4 To play your program, press
PLAY•PAUSE 2;.
Reviewing your program
• In the STOP mode, press and hold down
CD MODE/ PROGRAM for more than
one second.
The display shows all your stored track
numbers in sequence.
Great user manuals database on
14-11-2000 19:17 Pagina 13
and
PROGRAM
UserManuals.info
Cassette Recorder
Erasing a program
You can erase the contents of the memory
by:
– opening the CD door;
– selecting RADIO or TAPE source;
– pressing STOP 9 (twice during playback
or in the stop position.)
Display: shows ' no P ro g' briefly when
the program is cancelled.
CASSETTE RECORDER
Cassette playback
1 Adjust the POWER slider to TAPE/
2 Press STOP•OPEN 9/ to open the
cassette door and insert a recorded
cassette.
3 Close the cassette door.
4 Press PLAY 1 to start playback.
Display: shows tAPE throughout tape
operation.
5 To pause playback press PAUSE ;.To
resume, press the key again.
6 By pressing 5 or 6, fast winding of the
tape is possible in both directions.To stop
fast winding, press STOP•OPEN 9/.
7 To stop the tape, press STOP•OPEN 9/.
• The keys are automatically released at the
end of the tape, the tAPE indication goes
out and the set is switched off, except if
PAUSE ; has been activated.
.
OFF
13