Publicité
Les langues disponibles
Les langues disponibles
18. GENERAL SPECIFICATION
Waveform
Amplitude
(over 500 Ohm load)
Output plug
Channels
Batteries
Weight
Dimensions
Safety Classification
Environmental specifications:
Operating:
Storage:
TYPE BF
EQUIPMENT
IP22
Note: The electrical specifications are nominal and subject to variation from
the listed values due to normal production tolerances of at least 5%.
Note: At least 30min required for the device to warm / cool from the minimum
/ maximum storage temperature between uses until it is ready for intended
use.
Symmetrical biphasic or monophasic rectangular
80 mA zero to peak +ve in 20 steps.
+/- 10%
Fully shielded: touch proof
Dual channel
2 x AA alkaline (two AA batteries)
140 g without batteries
100 x 67 x 32 mm
Internal power source.
Designed for continuous use.
No special moisture protection.
Temperature range: 5 to 40⁰C
Humidity: 15 to 93% RH non-condensing
Atmospheric pressure: 70 kPa to 106 kPa
Temperature range: -25 to +70⁰C
Humidity: Up to 93% RH non-condensing
Equipment providing a degree of protection against
electric shock, with isolated applied part.
This symbol on the unit means "Refer to Instructions for
use".
The unit is not water resistant, and should be protected
from liquids.
Complies with EU WEEE regulations
24
Publicité
